Model Number

TP2000

Function explain:
    This machine have powered outfeed conveyor and powered conveyorized turntable system and is able to transport an wrapped load from the turntable to the outfeed conveyor if there is no wrapped load on the outfeed conveyor.
     The operator can start wrap cycle by remote control and the film is automatically attached and cut, allowing the operator to do other tasks.
     This arrangement eliminates the need for operators to place unwrapped loads on the floor, then pick them up again when the turntable is clear. During the machine auto wrap one palletized load, the operator can get one new unwrapped load, if there is no pallet on turntable, operator can put the new one, then take the wrapped load from the outfeed conveyor to the warehouse. Compared to a single turntable system. It increases forklift efficiency and reduces handling time.
    
 Controls  
     - OMRON PLC Programmable Logic Controller
     - Separate Carriage Up-Down Speed Control
     - Auto-Height Load Height Sensing
     - Electronic Film Tension Control
     - Conveyor Jog (for each conveyor)
     - Dust-tight Precious Metal Slip-ring for long reliable service
     - **Additional Controls may be required
    
  Table Drive &Support
     - 0-12 RPM Variable Table Speed (Higher Speeds Available Where Required)
     - Adjustable Soft-Start Soft Stop
     - Table Fully Shrouded for Greater Personnel Safety
     Turntable Conveyor
     - Heavy structural steel Frame construction
     - Heavy duty Bearing Roller Suppor
     - Soft-Start, Soft-Stop
     - **Different Roller Diameters and Roller Spacing Available for a variety of applications
     In-feed/Out-feed Conveyor Sections (Included)
     - Heavy Structural steel Frame construction
     - Heavy duty bearing roller support
     - All rollers driven
     - Heavy Duty Conveyor Guards
     - Adjustable Leg Height
     - Different Roller Diameters and Roller Spacing Available for a variety of applications
     - Photo-eye Pallet Sensing and sequencing
    
   Film Delivery System
     - Powered pre-stretch system up to 200% to min film consumption
     - Carriage door opens for effortless roll change and thread film
     - Film delivery variable speed by separate DC Drive Motor
     - Film dancer-bar with variable speed output
     - Prestretch Ration Set to Customers Requirements (200% Std)
    
   Film Carriage Drive
     - Two Heavy Duty ANSI #50 Chain Lifts (2)
     - Programmable 3/4" HP Variable Speed AC Drive Motor
     - AC Motor Control Board
     - UHMW-PE Glides on 3/8" CRS Ways (No Maintenance Lifetime Warranty)
    

Film Tail Treatment
     - Adjustable Film Roping
     - Pneumatic Film Clamp
     - Pneumatic Film Alignment Arm
     - Pneumatically Activated, Thermostatically Controlled Cutting Device
     - Pneumatically Activated Brush
         
     Other
     - Hinged mast for easy handling
     - Forklift transportable
        
    Technology Parameter
     Max load size(mm): 1200(h)*1200(W)*2400(H)
     Turntable diameter: 1800mm
     Turntable Height: 400mm
     Turntable weight capacity: 2000kg
     Packing Height: 2400mm(max) tailored on needs
     Machine weight: 1400kg
     Electrics: 220V 50HZ 1Phase
     Turntable speed: 1-12rpm
     Air : 0.4-0.6 MPA